Posts Tagged 'whipped stem stitch'

whipped satin stitch

Posted by on 05 Jan 2010 | Category:

Like many other whipped stitches, a contrasting thread is ‘whipped’ over the satin stitch.

You need to know the satin stitch to be able to do this stitch.

whipped_satin_stitch          whipped_satin_stitch_2
Fig 1: First, lay the foundation by doing satin stitch. Use a contrasting colored thread to ‘whip’ over the satin stitch. Bring the needle out through A and take it diagonally into B. Then, bring out through C which lies vertically below B, and continue the process of whipping.   Fig 2: After finishing the finished pattern would look like this. 

whipped stem stitch

Posted by on 17 Mar 2009 | Category:

 

whipped stem stitch 1     whipped stem stitch 2
Fig 1: Lay a foundation of stem stitch. Bring out another thread through the start point and pass it through the first stem stitch.   Fig 2 : Continue this winding action between each stem stitch.
     
whipped stem stitch 3
Fig 3: you should finally get a pattern as shown.

NOTE:
Make sure the fabric beneath is not plucked while whipping the thread around the stem stitch. Use a blunt needle to acheive this.

whipped back stitch

Posted by on 28 Feb 2009 | Category:

This variety gives a twisted effect like what you will see in a whipped running stitch.

back_stitch_foundation
Back stitch: Lay the foundation by doing a back stitch.

whipped back stitch1       whipped back stitch2
Fig 1: Take another thread and needle and bring it out through A. Pass the needle under the stitch A-B, from above, as shown. Do not pluck the fabric underneath.   Fig 2: Similarly, pass the needle under the stitch B-C, from above, as shown.
   
whipped back stitch3
Fig 3: Continue this process of taking the needle under each back stitch foundation to give it a twining effect.

 

NOTE:
Make sure that while taking the needle and thread under each running stitch, you do not pluck the fabric underneath. You can use a blunt needle to acheive this.
Make sure to leave the back stitch just a bit loose in order to allow the other thread to pass through it easily
.